MARES PURE PASSION Eos Alpha Flashlight

TECHNICAL CHARACTERISTICS: • Max depth - 50 m/164 ft. • Switch - Magnetic slider, 2 positions (Off Fig.2A, ON Fig.2B). • Batteries (not included) - 4 AA Alkaline or 4 AA rechargeable (2700mAh); Burn time: Over 15 hours. • Reflector - Polycarbonate (Hot Spot). TO REPLACE BATTERIES: • Unscrew the head of the torch (Fig.1A), holding it pointing upward then remove the LED holder (Fig.1B). • Insert the batteries, paying CLOSE ATTENTION to their orientation, respecting the polarity shown on the stickers (Fig.4). • Put the LED holder back in the correct position (Fig.3) and screw down the reflector holding nut (head) completely. CARE AND MAINTENANCE: • Respect the polarity of the batteries as shown in this manual and inside the torch. • Remove the batteries if the torch will not be used for long periods or during transport. • Do not use the torch out of the water. • AFTER EVERY USE CHECK THAT THE TORCH WAS CORRECTLY SWITCHED OFF. • Replace ALL the batteries when they are dead, to avoid damage or injury to the torch or people. • Do not unscrew the reflector holding nut (head) of the torch during a dive or when wet. • Before screwing on the nut (Fig.1A) grease the two O-rings (Fig.1D) with silicone grease (Mares Code: 415147) and ensure their leanliness. Periodically (once a year), have the integrity of the O-Rings checked at a Mares Service Center (www.mares.com). • If water leaks occur or in the event of a malfunction, contact the Mares Dealer where you purchased the torch or a Mares Service Center. • Use of expired batteries can significantly reduce the burn-time and performance. • A decrease in light intensity and/or a slight flicker in the beam indicate that the batteries have nearly lost their charge. They should be replaced at the next opportunity. ROUTINE MAINTENANCE: • Rinse the outside of the torch in fresh water after every dive, without disassembling it. • Keep the torch in a cool, dry place. The temperature must never exceed 50°C.