CRESSI Plasma Shaft 6.25 mm 110 cm

Realized with a few parameters of endings and really strict levels for a greater adjustment to all kinds of mechanisms. Mechanized made with useful stainless hard metal to avoid the pollution of the material of the shaft and possible points of oxide of the mechanized zones. SANDVIK steel hardened externally through an exclusive plasmatic vacuum process in high temperatures. This process makes the external part to have a hardness about 60 HRC without harming the resistance to the flexion of the shaft. Process of very strict control (shaft by shaft before to the mechanizing) to verify the perfect straightness of the shaft. Flap in stainless steel of wharf AISI 301 of 0,8 mm thickness. Mechanical resistance 1269 Nw/mm2 near to the one of the shaft. Pin and orifice provided to the diameter of the shaft between 2 and 2,5 mm. Length in proportion to the shaft; 55 mm in measures from 90 to 120 cm and 70 mm from 130 to 150 cm. Flap of two volumes, studied for the maximum hydrodynamics. Assembly with one light reducing of 1cm of length that integrates in the profile the rivets and improves notably the scope of the shaft. The reducing does not suppose wastage of resistance since the pin of fin is provided according to the diameter of the shaft. O-ring of enclosure of the flap included (red color). Reinforced pins with curved radius of mechanization. Polyvalent design for metallic wishbone and of Dyneema. Material and adjustment system of high tenacity, which guarantees a resistance of 340 kg of tension. Top format wishbone specially resistant and of great penetration. Features: - SANDVIK steel hardened externally through an exclusive plasmatic vacuum process in high temperatures. This process makes the external part to have a hardness about 60 HRC without harming the resistance to the flexion of the shaft. - Reinforced pins with curved radius of mechanization. Polyvalent design for metallic howitzers and of Dyneema. - Material and adjustment system of high tenacity, which guarantees a resistance of 340 kg of tension. - Flap in stainless steel of wharf AISI 301 of 0,8 mm thickness. Mechanical resistance 1269 Nw/mm2 near to the one of the shaft. Pin of 2mm. Completely matte finish to avoid brightness. Length in proportion to the shaft; 55 mm in measures from 90 to 120 cm and 70 mm from 130 to 150 cm. Inserted in the shaft without reducing thicknesses to avoid damaging the top´s resistance. - Top format wishbone specially resistant and of great penetration. - Completely rounded profiles of mechanized areas. Realized with a few parameters of endings and really strict levels for a greater adjustment to all kinds of mechanisms. - Process of very strict control (shaft by shaft before to the mechanizing) to verify the perfect straightness of the shaft. - O-ring of enclosure of the flap included (red color). - Diameter: Ø6,70 mm y Ø7,5 mm. Specifications: - Ø6,25mm 110cm